Description
Low amp draw DC fan (2.0 amp startup and 1.7amp continuous) does not over tax the electrical system. Heavy duty welded aluminum design is rugged enough to take abuse but lightweight Pulls approximately 225 CFM (cubic feet per minute) of air through the clutch ductwork enhancing the OEM clutch fan Air is removed from the clutch housing and fan installation does not inhibit or otherwise interfere with belt changes Active venting system that expels hot air even at low ground speeds as opposed to OEM rpm dependant clutch mounted fan Clutches and belt stay cooler which allows them to last longer and work better. Belt dust and other fine debris are essentially vacuumed out of the clutch cover area so clutches stay cleaner. Factory connector allows true plug and play install. Also allows quick disconnect for troubleshooting and repair work on machine. Includes: All Necessary Hardware to Install onto Machine UTV’s weigh more and carry more cargo than ever thought possible from an ATV platform. The clutches and drive belt show up as a weak link as the added load is converted to wasted heat energy. This waste heat deteriorates drive belts, and breaks down composite bearing surfaces and parts which lead to increased inefficiency. This loss of efficiency only provides more ways to make heat and the vicious cycle repeats until failure. “THE BLOW HOLE” for UTV’s brings our respected and valued snowmobile product along with its heat fighting abilities to increase the longevity of the drivetrain and ultimately your investment. We developed this out of a desperate need to increase belt and clutch life on rental machines we have run on the sand dunes. Out in the extreme conditions of the sand dunes it has become common
